Large volume subcutaneous delivery using multi-orifice jet injection.

Needle-free jet injection is an alternative drug delivery technique that uses the liquid drug itself to penetrate through the skin. This technology is not only a promising alternative to hypodermic needles but also has the potential to replace intravenous delivery with rapid, needle-free subcutaneous delivery for large-volume treatments. In this work we propose a parallelised, 'multi-orifice' approach to overcome the volume constraints of subcutaneous tissue. We present a prototype multi-orifice nozzle with up to seven orifices and use this nozzle to perform injections into samples of ex vivo porcine tissue. These injections demonstrated the rapid (<0.15 s) delivery of up to 2 mL into the tissue using both three and seven orifices. Delivery success (measured as the percentage of fluid deposited in the tissue relative to the total volume that left the device) was very similar when using three versus seven injection orifices. A computational fluid dynamic model of multi-orifice jet injection is also presented. This model predicts that jet production is largely unaffected as the spacing between orifices is changed from 3 mm to 48 mm. This finding is supported by measurements of the speed, volume, and shape of the jets produced by the prototype nozzle that showed very similar jets were produced through all seven orifices. These findings demonstrate the feasibility of multi-orifice jet injection for needle-free delivery of large volumes. This promising technique has the potential to improve patient experience and reduce healthcare costs in large volume parenteral delivery applications.

Rotatable Orifice for Needle-Free Jet Injection.

This research explores a new development in orifice technology for needle-free jet injection. The premise lies in the ability to control the angle at which the drug is delivered into the tissue to increase the lateral dispersion of the drug. Towards this aim, a spherical orifice that can rotate to adjust the injection angle is explored. This work tests the design and feasibility of the spherical orifice, its housing, and the orifice seats. The results show that the most successful way to create a fluid seal within the housing was to use an o-ring to create a fluid seal at the inlet side of the sphere and an extended brass seat on the outlet side of the sphere. This allowed jet speeds up to approximately 123 m/s through a 0.2 mm orifice machined into 9.5 mm diameter brass sphere. Jet speeds large enough to penetrate porcine tissue were reached at jet angles of 0° to 50° relative to the base of the injector. Although the jets successfully penetrated the tissue, the amount of fluid delivered varied depending on the injection angle. With a shallow angle injection, the fluid retention rate (the percentage of the ejected fluid from the injector which the tissue sample retained) was on average 44%. When the spherical orifice was at its maximum angle, the injection achieved an average fluid retention rate of 22%. At its widest angle, lateral dispersion of the drug also increased by approximately 40%, in comparison to conventional needles and traditional perpendicular jet injection. In summary, a spherical orifice needle-free injection system successfully produced high-speed jets and delivered liquid into porcine tissue at injection angles from 0° to 50°, demonstrating the feasibility of this technique that offers unique advantages over typical orifice plates and conventional needles.Clinical Relevance-A rotatable nozzle can be used to control the angle of needle-free drug delivery.